News about renewable energy and electric vehicles
How to

How To Save On Boiler Operation Costs?

lowering boiler operation costs

Serving the Glasgow area for more than two decades, stands ready to provide full boiler and heating system repair assistance.

They are proud to provide the following advice to help you achieve real savings on utility bills while running your boiler efficiently and safely.

Tips to Lower Boiler Operation Costs

1. Use an efficient thermostat

The first thing to keep in mind is to always make use of an efficient thermostat in conjunction with thermostatic radiator valves. This helps power the energy consumption of your boiler by a rate upwards of 40%. This type of equipment is best installed by a fully-trained boiler repair technician.

2. Run the boiler with a timer

Also make sure to run the boiler with a timer that is able to switch the system off when heat is no longer essential, such as when the household is away at work or school.
The energy savings through just this technique alone can be substantial.

To make some serious savings, let the boiler run until it reaches the top temperature of the water, and after that switch it off.
This way you cane make huge savings just because the boiler will not start when somebody is using the tap.
Every time is somebody using the tap, some hot water from the boiler will be consumed and replaced with cold water.

This way the boiler needs to heat the water again and this way consumes more power.

However, if you switch off the boiler when is full (and switch it back on when is empty) the water heater will work only a couple of hours per day, and this will mean huge savings on your energy bill.

3. If your boiler is very old, replace it with a new one

If you have a boiler that is a decade or more older, consider making a full replacement with a new model that is energy efficient and potentially capable of lowering consumption by roughly 33%.

4. Lower your central heating system temperature by one degree

Remember to lower your central heating system by a degree in order to achieve utility savings of 10%. If you reduce the temperature of your immersion heater, you can also achieve real savings, and you probably will not even notice the change.

It really does pay to lower your thermostat, even if just by a little. A single degree change can cut energy use by roughly 5%, and it is best not to heat any parts of the house that are not being used.

Lowering the temperature of your hot water (there is no need for anything higher than 140 degrees Fahrenheit) is a sensible move, because having it set too high just requires it to be mixed with cooler water so that it can be used, which makes little sense overall.

5. Upgrade your home’s heating controls

Take steps to upgrade the home’s heating controls so that the central system works as efficiently as possible. The savings that result can reach 20%. This ought to always be done by a skilled professional.

6. Have your boiler serviced and maintained regularly

Always have your boiler serviced and maintained regularly. With routine inspections and service, boilers are less prone to expensive and potentially dangerous breakdowns. Your equipment will last longer, and you will achieve impressive energy bill savings.


Finally, consider swapping showers for baths. Baths use vastly more water than quick showers, and the cost to heat that water can prove exorbitant over time.

Article written by:

I am a writer and reporter for the clean energy sector, I cover climate change issues, new clean technologies, sustainability and green cars. Danny Ovy

Leave a Reply

© 2012 - 2021 -